HelixFeed Tester Guide

Build version: 0.8.5

What HelixFeed is:
- A Fusion 360 feeds-and-speeds assistant for milling-focused CAM workflows.
- A starting-point recommendation tool, not a replacement for machinist judgment.

What I need from you:
- Try HelixFeed on real Fusion CAM setups you already understand.
- Compare the recommendation to what you would normally run.
- Tell me when the recommendation feels right, too aggressive, too conservative, or mapped to the wrong tool/strategy.

What to pay close attention to:
- Tool classification
- Machining mode selection
- RPM / feed plausibility
- DOC / WOC plausibility
- Whether Apply writes back correctly to Fusion
- Any operation that looks obviously misclassified

Current scope:
- Fusion 360
- Milling-focused workflows

Known limitations:
- Turning is not supported
- Tapping is recognized but not yet authoritative

Important:
- Always review the toolpath and cutting data before posting code or cutting material.
- Do not rely on HelixFeed without your own verification.
